5.2. Anchor Tie Bars
For connecting and anchoring formwork- For in-situ and precast component construction work
- 5 different anchors Ø from Ø 15.0 mm up to Ø 36.0 mm
- Bars can be supplied in hot-rolled or cold-rolled versions
- Permissible service loads from 85 kN up to 549 kN
Catalogue
complete with plastic sleeve
Available variants
Available variants
yellow
Available variants
galvanized
D&W 15 mm, tempered cast, raw material,
Available variants
raw material, adm. load 250 kN
Available variants
adm. Load 250 kN
Available variants
with tie bar and welded sheet
Available variants
accessory to water stop, galvanized, SW36
Available variants
plastic, for easy removing of the steel cones
Available variants
SW 41, to remove steel cones
Available variants
tempered cast, with welded sheet 120 x 120 mm
tempered cast, with round sheet
grey, raw material
Available variants
accessory for water stops
for plastic tube D&W 20 mm
Available variants
with grooves, grey, fitting to plastic tube
Available variants
